| H BEAM SHOT BLASTING MACHINE |
H BEAM AND PLATE |
HOOKING TYPE SHOT BLASTING MACHINE |
TRACK TYPE SHOT BLASTING MACHINE |
| play |
play |
play |
play |
Our Main Products:
Crawler shot blasting machine, rotary blast machine, hook type shot blasting machine, shot blasting machine by type, car type shot blasting machine, shot blasting machine spin chain, loose sand machine, sand mixer, steel shot steel sand
Provide a variety of shot blasting machines maintenance, and accessories sale items service. Welcome your inquiry!
Crawler shot blasting machine safety operation
First, turn the power front view, shift records;
Second, set working hours, work can not adjust the time before shutdown;
3, Bahrain jobs, open the door to see whether the parts inside the chamber, the normal turn, stop, close;
4, followed by open fan, track forward, shot blasting, lifting machine;
5, set the time that the track is only a fan switch work;
6, open the door, reverse the workpiece track;
7, upgrade with, track tension should be maintained and, if loose, tension in time. Can not be offset, if offset, in time than now;
8, to observe the marked slowdown in oil is short of petroleum;
9, for any repairs should be off the power.
Track shot blasting machine repair and maintenance
1. Always check inside the rubber track shot blasting room, interior linings, etc., should be immediately replaced after wear.
2. Regularly check the wear of blast wheel inside, wear over the limits that should be replaced, especially leaves, directed sets, sub-pill wheel and impeller should pay attention to, if not promptly replaced, would generate abnormal vibration, ability to shot down, also whole body vibration. Another blast wheel liner wear, if serious, it should be replaced, otherwise the blast shell of easy to wear, or even breakdown, causing the projectile flying machine, the harmful environmental and personal safety.
3. Shot blade replacement, be sure to balance and shot blasting chamber orientation sets the adjustments. Replacement blades, generally the opposite direction is symmetrical to replace the two blades, the weight must be equal.
4. Regularly check whether the oil seal leakage, regular open repair blast wheel spindle.
5. Regular cleaning both inside and outside the body to keep clean. Dust regularly inspected bodies, with particular attention to parts of the bearing to prevent the dust into the bearings inside the bearing damage.
6. Lubrication of the machine is properly will seriously affect the life and good machine performance and must therefore be carried out step by step correct lubrication and maintenance, please press the table Lubrication:
Lubrication oil lubrication time point
100 hours of high-speed motor bearing lubrication
Cycloid reducer oil as the oil above 60 # set foot line
Chain lubricants for more than 60 # 1 month
Side plate bearing grease for six months
Other bearing grease 1 month
|
Small casting workpiece